Flow temperature value

Hi,

I use Vectrino in Hydraulic Laboratory. I need to extract temperature value from my recorded files (*.vno). Is it possible to do it? Also only one value that Vectrino plus shows at the start of flow measurement is adequate or any method to estimate the flow temperature using my recorded vno files.

Thank you in advance!

Ali

Dear Ali,

The Vectrino is only reporting the temperature at the beginning of the measurement. 

Please check http://www.nortek-as.com/en/knowledge-center/forum/software/918921547#218152847 for further discussion.

Best regards

Jonas Røstad